XSpearmint
Registered on
Aug-03-2007
More User Info
|
Message #71867 posted by XSpearmint (Info) August 03, 2007 04:01:12 ET
In Reply to: Re: Growing Cannabis In Complete Darkness posted by FrankWills (Info) May 26, 2007 17:04:22 ET
Hello Frank Wills!
I am operating under limited conditions, where there is very little margin
for error.
I'm trying to get Radionics right the first time around.
Currently I am working towards setting up a radionic grow room modeled
after your description in the pdf. There are a lot of specifics I am not sure
about, but the main technical issue I am grappling with is how to work in a
timer mechanism to induce flowering earlier in the season, I suppose I could
set up a switch that could be manually flipped on & off, but I wish to establish
an automated timer to control the "photoperiod?" (not sure if that’s the right
term to use in this circumstance).
You did make mention to this in your pdf, but I am still at a loss.
You wrote:
"When integrating a timing device into the station in an effort to time the
station’s state from on to off allowing us to provide timing for our nighting
cycle etc. All one need do is place the timer’s output in between the bottom
sheet and earth. This will switch the unit on and off at pre designated times."
You also wrote:
" the electrical mains …can and will interfere with the stations efficiency
through electrical … leakage currents."
So should I put 2 & 2 together and assume that an electric timer can be used
to induce flowering (a 12/12 cycle) by wiring live electricity from an
household outlet to the Earth/Ground wire, then setting the timer so that the
times I desire the Radionic system to be "off" are actually indicated as "on"
points on the timer. My guess is that when the timer switches to "on"
electrical current will flow through half of the radionic system disrupting the
radionic flow and thus acting as a night cycle.
I know this is a long shot, but am I close? Way off?
When you wrote "place the timer's output in-between the bottom sheet and
earth." By "earth" were you referring to the wire that runs into the ground, or
did you mean that the timer's output need be placed above ground but below
the bottom sheet?
-I'm not exactly sure how either would be wired.
You’re the man with the plan so any & all info you could offer to me about
setting up an automated timing mechanism for a radionic grow system would
be VERY much appreciated.
|
