dryashell
Registered on
Jan-17-2007
More User Info
|
Message #45454 posted by dryashell (Info) July 31, 2007 00:37:18 ET
In Reply to: Re: How to load a bowl... posted by potheadsrus (Info) July 29, 2007 21:43:13 ET
ok, my friend's all suck at rolling blunts, I know how to make a THICK blunt with a Black and Mild, but im lazy, 90% of the time I use my pipe, here's the best way to do it.
Start off just pulling little pieces off, a "pinch" is the best way I can say, the reason is to get alot of the seed's and stems out.
While doing this, set aside one piece that looks big just slightly larger then the hole in the pipe, dont jam it into the hold of this will plug you making it hard to smoke. I use the small piece to prevent the ginded ammount from falling through.
Pile your grinded ammount ontop of the small but you used to cover the hole, press gently to make it nice and tight.(works best if your green isnt to dry, but it should work both ways)
after that light up! also, dont pull any of the top of the green off till you see a little white ash, this way you know that the top is spent, and the bottem is about half used, at this point I like to remove it all and roll it into little balls, what doesnt fall off you can keep smoking if you want. I normally do, there's normally a little bit left in it.
once agian after the tip top turns white. if you still need it repeat the process, I always do this when i smoke from my pipe and I get pretty messed up. Hope this help's you!
|
